6
Installation
1
Preparation for mounting
2
Preparation for mounting
□
Tighten the support screws (B) full turns into the inside
mounting hole of mounting strip (A) (to be fully tightened
later), secure by G5/32” hex nut (F).
NOTE: The support screws (B) should extend
long enough to protrude through the canopy (H)
when it is mounted. (Adjust as needed)
□
Fasten the mounting strip (A) onto outlet box using two
outlet box screws (D).
3
Connect the wire
4
Cover the wire with wire
connector
□
Strip 3/4” of insulation from the wire ends. Twist the
stripped ends together with pliers. The black wire from the
fixture to black wire from outlet box, white wire from the
fixture to white wire from outlet box. The bare copper
grounding wire from the fixture must loop one turn under
the head of green ground screw (C) on the mounting strip
(A) before it is connected to the grounding conductor of the
supply circuit.
□
Cover the wire with wire connectors (G). Tape the wire
connector (G) and wire together. Carefully position all
wirings inside outlet box.
B
A
F
D
A
B
F
G