5
Installation
1
B
2
Loosen the track mounting screws (A) preassembled to the
mounting plate (B).
Do not remove the track mounting screws (A) completely.
Field cutting the track to special lengths (Optional)
Separating the canopy
F
NOTE:
Cutting should be done preferably from the dead end of the track.
□
□
□
Remove the canopy screws (E) from the canopy (D) to
expose the mounting plate (B).
B
A
C
D
E
□
□
□
□
□
□
□
□
□
the end of the track (F).
(cut straight down through the track).
Remove all burrs from the track, insulators, and copper bus
bars so the end is smooth to the touch.
Slide the copper bus bars and insulators back into the track
leaving approx. ¼ in space between the end of the track and
the insulator, copper bus bar assembly.
length of track that is 4 ft. or less in length has one mounting
opening spaced a maximum of 6 in. from each track end
section. A single section of track that is greater than 4 ft.
in length must have mounting openings a maximum of 12 in.
from each end of the track with additional openings a
minimum of every 4 ft. along the length of the track section.
Additional openings every 4 ft. along the track section may
be added as needed.
tension screw.
Align the track so the open side is facing upward (the side where
the copper bus bars are exposed).
Using a Philips head screwdriver, loosen the tension screw and
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
