2.
Connect brown cable wire of new scanner to the same terminal on the line box to
which the original brown lead was attached.
Skip one terminal and connect the extended red lead to the terminal where the orange
lead of the old scanner was removed. Connect shielded leads to recovery amplifier
boards.
3.
The remaining leads are connected to the vibrato switch terminals.
Facing the rear of the organ, leave the first terminal (closest to the rear) open.
4.
Refer to Figure 5-13 in referenced manual. Connect leads of new scanner according to
the following :
Orange wire to Terminal 4
Yellow wire to Terminal 6
Green wire to Terminal 8
Blue wire to Terminal 10
Violet wire to Terminal 12
Gray wire to Terminal 14
White wire to Terminal 16
5.
Fasten animator assembly in place and reattach shield cover.
6.
Close organ.
Page 2 of 2
-80-
