49
90
80
85
20
25
10
15
0
5
40
0060-
885
"
#
!
$
"
#
!
$
Edge sanders
HS 950
11.6 Adjusting the angle - Sanding module inclination
90° - Angle :
1.
Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2.
Release the clamping lever.
3.
Loosen the locking nut.
4.
tilt in 90 degrees direction
5.
Place the test piece or 90° angle on the working
table and the grinding belt support.
6.
adjust the fence screws (set at 90°)
7.
Tighten the lock nut again.
8.
Test the adjustment and if required, readjust.
!
Clamping lever
"
90° stopscrew
#
Locking nut
$
90°- Angle
0° - Angle :
1.
Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
2.
Release the clamping lever.
3.
Loosen the locking nut.
4.
tilt in 0 degrees direction
5.
Place the test piece or 90° angle on the working
table and the grinding belt support.
6.
adjust the fence screws (set at 0°)
7.
Tighten the lock nut again.
8.
Test the adjustment and if required, readjust.
!
Clamping lever
"
90° stopscrew
#
Locking nut
$
90°- Angle
Fig. 11-2: Adjusting the angle - 90°
Fig. 11-3: Adjusting the angle - 0°
Faults
Summary of Contents for HS 950
