8
Woodstock Multifuel Stove
INSTALLATION
FIREBOX LINER PANELS
Your Hamlet stove uses firebox liner panels to the
sides and back. The throat plate sits on top of the
side and rear panels and has a removable wood
burning tray in the base of the stove. These should
come fitted to your fire, if however they are not
proceed as follows to fit them.
Note: All the liners are the same size.
•Set one of the liners into the back of the fire.
For finished layout see Fig. 1.
•Insert 3 liner panels into each side of the fire.
•Fit the throat plate with the single bend and two
cut outs to the front facing up (Fig. 2).
The projecting lugs sit on top of the side liners.
The long centre tab on the back edge rests on the
rear liners. The shorter tabs against the vertical face
(See Fig. 3).
Note: Neither the rear firebox liners nor the side
firebox liners are "handed", both faces are
suitable for direct contact with the fire. Cracking
of lining panels does not effect efficiency.
Fig. 1
Liners setup for the stove.
Fig. 2
Inserting throat plate
Fig. 3
Liners and throat plate
in the stove.
REMOVAL OF THE THROAT PLATE
Blocked chimneys cause dangerous fumes to
escape. Remove throat plate at least monthly to
clean. Keep chimney and flue ways clear.
FITTING THE FEET
The Woodstock stove
must be
fitted with the feet
supplied.
Care should be taken whilst assembling the feet so
as not to damage the painted surface of the fire.
•The feet are positioned in each corner of the
fire and fixed using the washers and screws
provided.
•
You will need a no. 2 pozidrive screwdriver
to tighten the screws see Fig. 4
Fig. 4
Fitting the feet
