8
3.2 Decrypt
Once you set the encryption on the device, you must unlock the
hard disk using one of the RFID key included to display and transfer
your data, as shown in the following steps.
1. Connect the encrypted external drive to the computer.
2. The external drive will give off one short beep sound and the
Red light (K) will be switched on.
3. Take out one of the RFID key and close it to the induction area.
Two short beep sounds will be given off and the Green indicator
(L) will switch on. If only one long sound will be given off, the
decryption failed. Please try another RFID key.
4. The external drive will be ready to work after the system
recognize it.
3.3 Remove the encryption
1. Please backup the data in the hard drive and connect it to the
computer (with any other external enclosure).
2. After the system recognizes the hard drive, setup the partition
again.
WARNING
: If both keys are lost when the drive is in
encrypted
mode your data will not be recoverable.
3.4 Remove the device
1. Before disconnecting the device, use the RFID key and close it
to the induction area to encrypt the hard drive.
2. The external drive will give off a one-short beep sound. The
Green LED (L) will disappear and the Red LED will lights up
indicating that the device is encrypted and ready to remove.
3. Now you can turn off the enclosure and disconnect it from the
computer.
