Technical Data Sheet
PROPRIETARY RIGHTS NOTICE This document and all information contained within it is the property of Hamilton Beach Brands, Inc. (HBB). It is confidential and proprietary
and has been provided to you for a limited purpose. It must be returned or destroyed upon request. Disclosure, reproduction or use of this document and any information
contained within it, in full or in part, for any purpose is forbidden without the prior written consent of HBB. No photographs may be taken of any article fabricated or assembled
from this document without the prior written consent of HBB.
Revision Description:
Production Release
Request Number:
DOC2649
Revision Date:
4/17/12
Approved by:
DOC2649
4421 Waterfront Drive
Glen Allen, VA 23060
Issue Code(s):
CS, SP
Page:
3
of
4
Document #:
520006200
Rev:
A
ENG-FRM-RIC-4.32, Rev. E
-5 VDC when pulse switch is activated.
-
“High” terminal lead connects to the bottom terminal of the hi/low/pulse switch.
-5 VDC while running on high speed.
-
“Low” lead connects to the center terminal of the hi/low/pulse switch.
-5 VDC while running on high or low speed.
Figure 3. PC Board
RFI Board
(see figure 4)
-
One white lead from the cord connects to terminal N. There should be no current reading.
-
The lead from the center terminal of the circuit breaker connects to terminal L202.
-
The lead from the motor ground connects to the GND terminal.
-
The lead from terminal P1 on the PC board connects to the P1 terminal on the RFI board.
-
The lead from terminal P2 on the PC board connects to the P2 terminal on the RFI board.
Figure 4. RFI Board
