2
IMPORTANT SAFEGUARDS
1.
Read all instructions.
2.
To protect against risk of electrical shock, do not put cord,
plug, base, or motor in water or other liquid.
3.
Close supervision is necessary when any appliance is used
by or near children.
4.
Unplug cord from outlet when not in use, before putting on
or taking off parts, and before cleaning.
5.
Avoid contact with moving parts.
6.
Do not operate any appliance with a damaged cord or plug,
or after the appliance malfunctions, or is dropped or damaged
in any manner. Call our toll-free customer service number for
information on examination, repair, or electrical or mechanical
adjustment.
7.
The use of attachments, including canning jars, not
recommended or sold by the appliance manufacturer
may cause a risk of injury to persons.
8.
Do not use outdoors.
9.
Do not let cord hang over edge of table or counter or touch
hot surfaces, including stove.
10.
Keep hands and utensils out of blender jar while blending to
reduce the risk of severe personal injury and/or damage to
blender. A rubber spatula may be used but must be used
only when blender is not running.
11.
Blades are sharp; handle carefully—especially when
assembling, disassembling, or cleaning inside blender jar.
12.
Do not use a broken, chipped, or cracked blender jar.
13.
Do not use broken, cracked, or loose cutting blade assembly.
14.
To reduce the risk of injury, never place cutting blade assembly
on base without blender jar properly attached.
15.
Always operate blender with lid in place.
16.
When blending hot liquids, open vent opening of lid, and close
any lid openings intended for pouring. If pouring with lid in
place, ensure the vent-opening cap is closed. Hot liquids may
push lid off jar during blending. To prevent possible burns:
Do not fill blender jar beyond the 3-cup (750-ml) level. With
the protection of an oven mitt or thick towel, place one hand
on top of lid. Keep exposed skin away from lid. Start blending
at lowest speed.
17.
Ensure collar on base of blender jar is tight and secure. Injury
can result if moving blades accidentally become exposed.
18.
If the jar should twist or rotate when the motor is switched
ON, switch OFF immediately and tighten jar in collar or on
blender base.
19.
Do not leave blender unattended while it is operating.
20.
Before plugging cord into wall outlet, turn the control to OFF
(
O
). To disconnect cord, turn the control to OFF (
O
). Then
remove plug from wall outlet.
21.
Do not use appliance for other than intended purpose.
When using electrical appliances, basic safety precautions should always be followed, including the following:
SAVE THESE INSTRUCTIONS!
840217701 ENv02.indd 2
840217701 ENv02.indd 2
5/16/12 9:16 AM
5/16/12 9:16 AM
