3
Blender safety
•
Read the Operation Manual before using
blender. Keep this manual handy.
•
Plug into a grounded 3 prong outlet.
•
Do not remove ground prong.
•
Do not use an adapter.
•
Do not use an extension cord.
•
To reduce risk of personal injury, unplug cord
from outlet when not in use, and before
putting on or taking off parts.
•
Do not store utensils or other objects in the
container since the blender would be
damaged if inadvertently turned On.
•
To prevent possibility of serious personal
injury, keep hands and utensils out of blender
container while operating blender.
•
Inspect container and cutter assembly daily.
Check cutter assembly for wear, nicks, and
broken or loose blades.
•
If cutter assembly blades are loose,
discontinue use immediately and replace
cutter assembly. Do not attempt to repair or
tighten cutter assembly.
•
Disassemble container assembly for
maintenance purposes only.
•
Replace container-cutter assembly at least
every 12 months or sooner if cutter assembly
blade appears worn or damaged.
•
Always operate blender with container, cover,
and filler cap in place.
•
Do not move or reposition base while unit is
On or operating.
•
Do not use outdoors.
•
Do not use with non-foods.
•
To reduce risk of personal injury and to
prevent damage to blender or container and
cutter assembly, DO NOT insert utensils into
blender container while operating blender.
•
To prevent damage to blender, container, or
cutter assembly, DO NOT move or shake
blender while in operation. If blending action
stops during operation, turn blender Off,
remove container from base, remove
container cover, and use a thin rubber
spatula to push mixture towards cutters.
•
Do not submerge or wash the blender base in
a dishwasher.
•
Do not place blender in or near water while in
operation.
•
Do not spray the blender base with a
high-pressure spray gun.
•
Disconnect power before cleaning.
•
Disconnect power before servicing.
•
Do not fill the container to a level higher than
the highest graduation marking.
•
To prevent burns from hot liquids splashing
out of the container, always remove filler cap
from container cover when blending.
•
Never exceed recommended volume when
blending hot contents.
•
Only authorized service/repair specialists
should repair the blender or open the blender
housing.
•
NOTE: Only use the Hamilton-Beach
1G91300 blender container (part number
6126-1G91300, as provided with the unit).
•
Do not operate any appliance with a
damaged cord or plug or after the appliance
malfunctions, or is dropped or damaged in
any manner.
• If the supply cord of this appliance is
damaged, it must be replaced by the
manufacturer or its service agent or a similar
qualified person. If fitted with a non-rewirable
U.K. plug, the 13 amp fuse approved by
ASTA to be B.S. 1362 must be used. If you
need a replacement fuse carrier, it must be
replaced by the same colour coded carrier
with the same markings. Fuse covers and
carriers can be obtained from approved
service agents.
IMPORTANT: If the molded plug is cut off,
dispose of it immediately. The plug is not
rewirable and would cause a shock hazard
if inserted into a socket.
–
SAVE THESE INSTRUCTIONS
–
IMPORTANT SAFETY INSTRUCTIONS
WARNING –
When using electrical appliances basic safety precautions should be
followed, including the following:
A-1G91300 ENv01 11/7/01 2:31 PM Page 3
