3
3.3 Setting mode introduction
Press and hold the scroll button when HUD is off then the power button while holding the scroll button
to enter the setting mode. In setting mode, press the scrolling button downwards to decrease the value,
and upwards to increase. The button right in the middle is for
Enter
,
Save
and
Exit
.
A1. Auto on/off mode (1~3 ): Mode 1 is suitable for 95% vehicles; If auto on/off cannot function in
mode 1, please reset to mode 2 or 3.
B2. Speed factor setting (80-120): The default setting is 108. Please adjust based on driving condition.
C3. Speeding alert setting
（
1-255
）
: Free setting
D4. Buzzer beating time (0-30s): Buzzer off when 0
E5. Gear Changing notice / Engine rotate speed(800-5000RPM): If such function needs stopping, please
adjust the value to 5000[The function matches to the fixed value of 60KM/H(35M.P.H). When settings
are finished into the parameter list, the data can be saved if the power switch shuts off]
Notice: How can you go into setting mode?
Press and hold the scroll button and to down direction when HUD is off then at the same time,
please turn on power switch. You can enter the setting mode.
4.Warning function
4.1 Speeding warning
The buzzer “ beep “ noise accurse & Flash light warning ( km/h red/green flash ) when speeding. The
sound will last for 5 seconds ( Default ) and mute automatically leaving only flash light warning.
4.2 Gear Changing Notice
The Gear changing notice buzzer will go on ( Beep noise ) when the engine rotate speed is over
2300RPM. The Gear changing Notice will disable when the speed is over 60km/h (35 mile/h )