background image

 

 

 

 

 

 

 

 

WARRANTY 

 

Hamar Laser Instruments, Inc., warrants each instrument and other articles of 

equipment manufactured by it to be free from defects in materials and 

workmanship under normal use and service, its obligation under this warranty 

being limited to making good at its factory any instrument and other article of 

equipment which shall within one year after shipment of each instrument and 

other article of equipment to the original purchaser be returned intact to Hamar 

with transportation prepaid, and which Hamar’s examination shall disclose to 

Hamar’s satisfaction to have been thus defective; other than this express 

warranty, Hamar neither assumes nor authorizes any other persons to assume for 

it any other liability or obligation in connection with the sale of its products. 

 

This warranty is not applicable to instruments or other articles of equipment 

manufactured by other companies and limited by a warranty extending for less 

than one year. In such an event, the more limited warranty applies to said 

instrument or article of equipment. 

 

This warranty shall not apply to any instrument or other article of equipment 

which shall have been repaired or altered outside the Hamar factory, nor which 

has been subject to misuse, negligence, or use not in accord  with instructions 

furnished by the manufacturer. 

 

The software described in this manual is furnished under a license agreement and 

may be used or copied only in accordance with the terms of the agreement.  It is 

against the law to copy the software on any medium for any purpose other than 

the purchaser's personal use. 

 

The information in this manual is subject to change without notice. No part of 

this manual may be reproduced by any means, electronic or mechanical, without 

written permission from Hamar Laser Instruments, Inc. 

 

©  Copyright Hamar Laser Instruments, Incorporated, 2019 

5 Ye Olde Road, Danbury, Connecticut 06810 

 

Summary of Contents for T-212










Reviews: