Hamamatsu ORCA-Flash4.0 LT3, Instruction Manual

Page: 42 / 47

ORCA-Flash4.0 LT3 Digital CMOS camera C11440-42U40 Instruction manual_Ver.1.1
40
Exposure time
Free running mode
3 ms to 10 s (Standard scan)
1 ms to 10 s (Rapid rolling)
Free running mode
/ Sub-array mode
129.99 µs to 10 s (Standard scan)
40 µs to 10 s (Rapid rolling)
External trigger mode
3 ms to 10 s (Standard scan)
1 ms to 10 s (Rapid rolling)
External trigger mode
Edge trigger / Global reset edge trigger / Level trigger
/ Global reset level trigger / Synchronous readout trigger
/ Start trigger
Software trigger input mode Edge trigger / Global reset edge trigger / Start trigger
External trigger input connector SMA connector
External trigger input level TTL / 3.3 V LVCMOS
External trigger input polarity Positive / Negative
External trigger input delay function 0 µs to 10 s (1 µs steps)
Trigger times
(at Synchronous readout trigger)
1 to 10 000 times (1 step)
External trigger output
Global exposure timing output / Trigger ready output
/ Programmable timing output / High output / Low output
External trigger output connector SMA connector
External trigger output level 3.3 V LVCMOS level
External trigger output polarity Positive / Negative
Programmable timing output
Reference signal Read End / Vsync
Delay 0 µs to 10 s (1 µs steps)
Pulse width 1 µs to 10 s (1 µs steps)
Image processing function Real-time defect pixel correction (ON or OFF)
Sensor temperature reading
function [unit]
1 °C
Interface USB 3.1 Gen 1 * 5
Interface connector USB MicroB type
Lens mount C-mount
*
1
Typical value
* 2 Digital binning processing in the camera.
* 3 Calculated from the ratio of the full well capacity and the readout noise median (Standard scan).
* 4 Calculated from the ratio of the full well capacity and the readout noise r.m.s (Standard scan).
* 5 Equivalent to USB 3.2 Gen 1 (SuperSpeed USB 5 Gbps)
(2) Power supply specifications
Camera
Input power supply DC12 V
Power consumption 45 W
AC adapter
Input power supply AC100 V to AC240 V 50 Hz/60 Hz
Typical output DC12 V
Power consumption 75 VA
Note
• Fluctuations of input power supply voltages are not to exceed ± 10 % of the nominal
voltage.