Hama RXTX2, Manual

Page: 5 / 8

5
Notes:
1. If, for some unknown reason, music can’t transfer out from Tx, you should restart Tx by turning it off and on
again.
2. If the connection is lost auto-reconnection should occur within a few seconds of the devices being brought
back into range. Otherwise, after about 60 seconds, Tx and Rx will go into Idle Mode to save power and the
blue LED will fl ash slowly (once every 5 seconds).
3. If a new Bluetooth stereo headset/audio receiver is nearby and in pairing mode, Tx may try to pair with it
instead of Rx.
4. In normal operation Tx+Rx will maintain their Bluetooth connection once they have been paired and swit-
ched on. If they disconnect or the link is lost, it maybe for the following reasons:
i. The range is over 10 metres between them or there is an obstacle in the way.
ii. Either device has been switched off or the battery needs recharged.
Visual Indicators
Status Indication
Pairing or connecting to another device High speed fl ash, several times per second
Connected Medium speed normal fl ash, once per second
Connected and music transfer is active (Rx only) Medium speed long fl ash, once per second
Idle mode Low speed fl ash, once per 5 seconds
Troubleshooting
Unit Symptom/Problem Solution
Tx & Rx With power switched ON no LED fl ashes
Check battery power.
Consult authorized dealer
Tx & Rx
Unit powers on with blue LED indicating pairing
mode but there is no connection to other unit
Ensure Rx and Tx are in range and in
pairing mode
Tx & Rx
Connection is lost.
Rx has been out of range of Tx for more than 60
seconds and gone into low power mode
Ensure Rx and Tx are in range switch
them OFF and On again.
00014102bda_GB.indd Abs2:5 00014102bda_GB.indd Abs2:5 12.06.2006 13:36:46 Uhr 12.06.2006 13:36:46 Uhr