31
Handling and operation
KHL 38
g
Handling and operation
Application instructions
■
Always set the correct temperature for the thickness of the laminat-
ing film being used.
■
When laminating thick paper or several sheets it is recommended
to use film with a low thickness.
■
Always wait until the first lamination is complete before starting the
next.
Switching the unit on and using it
Press the on/off button
8
to switch on the device.
Extend the rails to the film tray.
Hot lamination
After the device has been switched on, the default setting is 75 μ,
which is shown on operating control
2
as the corresponding
LED is illuminated.
To change the setting, press button
7
repeatedly until the LED
next to the required film thickness flashes
Place the document to be laminated in the appropriate pouch.
When the required operating temperature has been reached, the
corresponding LED stays lit.
Insert the film pouch into the front opening of the device. Make
sure that the sealed end is inserted first.
The document is returned at the rear.
If the item has not been fully laminated, repeat the first steps.
