Hama KHL37, Manual

Page: 31 / 166

31
Handling and operation
KHL 37
g
NOTE
► If the item to be laminated has not passed through all 4 rollers
approx. 15 seconds after the film pouch was inserted into the
device, the reverse function is automatically switched on and the
item is returned at the front of the device..
‹ Press button
7
if you wish to run the item through again.
DANGER
► Laminated items coming out of the device may be too hot to
touch.
NOTE
► The laminated item is hot and easily bent. Place the item on a
flat surface and leave to cool, so that it does not roll up.
Cold lamination
‹ After the device has been switched on the default setting is
75μm, which is shown on the display
5
.
‹ For cold lamination press button
6
repeatedly until “Cld” is
shown on the display.
5
.
‹ Place the document to be laminated in the appropriate pouch.
‹ If the device has been used for hot lamination it can take approx.
40 minutes until it has cooled down. The ready indicator
4
is
constantly illuminated.
‹ Insert the film pouch into the front opening of the device. Make
sure that the sealed end is inserted first.
NOTE
► Film pouches of all sizes should be inserted centrally into the
front opening, so that they pass by the sensor.
‹ The document is returned at the rear.
‹ f the item has not been fully laminated, repeat the first steps.