35
Removal of failure
KHL 48
g
Removal of failure
This chapter contains important information on cleaning and care of
the unit. Please observe the notes to prevent dangers and damage.
Safety precautions
WARNING
Observe the following safety precautions to avoid any injuries and
damage:
►
Repairs to electrical unit may only be carried out by specialists
trained by the manufacturer. Unqualified repairs can pose con-
siderable dangers for the user and serious damage to the unit.
Cause and removal of failure
The following table will help you locate and remedy smaller failures:
Fault
Possible cause
Remedy
No LED flashes
on the control
2
after press-
ing button
8
.
On/off button has not
been pressed.
Press the on/off button to
switch on the device
Mains cable not con-
nected correctly.
Make sure that mains
plug has been connected
to the mains socket.
The mains socket
does not provide any
voltage.
Check the fuses.
Unit is defective.
Contact after-sales
service.
Pouches are
not properly
laminated.
The temperature has
not been set to the
film thickness being
used.
Set the thickness to be
used in the device by
pressing the button
7
.
The inserted
pouch does not
come out the
rear side
The item to be
laminated is possibly
stuck or is too large
to pass through the
rollers.
Press the lever
4
down-
wards to dispense the
item from the front side.
Check that the item is
not above the maximum
allowed thickness.