10
• If no key is pressed for 30 seconds, the clock will resume the alarm l display.
To set the ALARM 2
• Press and hold the
SET
button for 3 seconds:
• The Alarm 2 hour digit will fl ash, then press the button or the button
to adjust to the desired hour.
• Press the
SET
button, the alarm2 minute digit will fl ash, then press
the button or the button to adjust to the desired minute.
• Press the
SET
button to show the current snooze
period with the minute fi eld fl ashes.
• Press the button or the button to adjust to the desired snooze
period from 1 minute to 59 minutes.
• Press the
SET
button and the alarm2 time is set and enabled.
• If no key is pressed for 30 seconds, the clock will resume the alarm 2 display.
Using the Alarm and SNOOZE for daily ALARM 1 or ALARM 2
• Press the
SET
/
SET
button to turn the alarm1 on, or the alarm1 off/ the alarm 2 on, or the
alarm2 off.
• When the current time reaches the alarm time that is enabled, the corresponding alarm is
activated.
• Press the
SET
/
SET
button when the alarm is activated will stop the alarm for 24 hours.
• When the alarm is activated, press the
SNOOZE • LIGHT
button and the alarm stops but sounds
again after the snooze period (4 minutes snooze period is pre-programmed).
• The repeat alarm indicator will fl ash.
• The alarm will stop after 4 minutes if the
SET
/
SET
button or
SNOOZE • LIGHT
button is
not pressed.
Receiving the radio control signal
The radio-controlled clock will automatically receive the radio signal every hour. It will take 3-5
minutes to receive the radio signal. If the DCF signal is received, the DCF tower will be visible on
the display, otherwise it will not.
Backlight
Press the
SNOOZE • LIGHT
button to light up the clock for 3 seconds.
Low battery level detection
Should the battery capacity drop to a level that is not suffi cient to operate the clock, the low
battery indicator will light up. The battery should be replaced as soon as possible.
Attention!
Please dispose of used batteries in an ecologically safe manner.
