Set Up:
• Insert
batteries.
• Use a pin to press the RESET button.
Radio Controlled Clock:
• The clock automatically starts scanning the RF 433MHz signal
to register new Thermo Sensor Unit after new batteries
inserted. After registered new channels or press “SEARCH”
button to stop scanning, the clock will then scan the DCF
frequency signal (“ ” fl ashes on the LCD ). Buttons will not
function while scanning for DCF or Thermo sensor’s signal
unless they are well received or stopped manually.
• The clock automatically scans the time signal at 3.00 a.m.
everyday to maintain accurate timing. For failed reception,
scanning stops (“ ” on the LCD disappear ) and repeats again
at 4.00 a.m. 5.00a.m. and 6.00a.m.
• The clock manually scans the time signal by holding “- / ”
(B8) button for 3 seconds. For failed reception, scanning stops.
(“ ” on the LCD disappear ).
• Press “HOLD” button to stop scanning when receiving DCF
signal.
“ ” fl ashes indicate now is receiving DCF signal.
“ ” turns on indicate signal received successfully.
“DST” shown on the LCD if it is in Daylight Saving Time Mode.
Manual Time Setting:
• Hold “MODE” button for 3 seconds to enter Clock/Calendar
setting Mode when viewing the Time.
• Press “+” or “-” buttons to adjust the setting and press
“MODE” button to confi rm each setting.
• The setting sequence is shown as follow: Hour, Minutes,
Second, Year, Month/Day sequence, Month, Day, Time Zone,
Day-of-week
language.
• 8 languages can be selected in Day-of-week, they are:
German, English, Russian, Denmark, Dutch, Italian Spanish
and French,. The languages and their selected abbreviations
for each day of the week are shown in the following table.
16
17
00092657bda.indd Abs1:16-Abs1:17
00092657bda.indd Abs1:16-Abs1:17
14.08.2009 9:45:07 Uhr
14.08.2009 9:45:07 Uhr
