g
Operating Instruction
9
After the drivers have been installed, click ->
Finish
. Now remove the driver CD-ROM from
your drive and keep it in a safe place in case
it is needed at a later date. You must restart
your computer before you can use the card.
You can check whether the controller has
been installed successfully under
Start ->
Settings -> Control Panel -> System -> Hard-
ware -> Device Manager.
The following must
appear without a yellow exclamation mark.
Universal serial bus controller
• NEC USB open host controller
• NEC USB open host controller
• USB
master
hub
• USB
master
hub
• USB
master
hub
Universal serial bus controllers
• NEC PCI to USB enhanced host controller
• USB 2.0 root hub device
Installation on Mac OS X 10.3.x or higher
Because Mac OS X 10.3.x or higher already
includes the necessary drivers, you do not
need to install any drivers separately. After
you have inserted the card into your MAC
and restarted MAC OS X, the computer
recognizes and installs the card after a short
time.
You can check whether the controller was in-
stalled properly by using the
System Profi ler
program. Check in USB to see if the following
entries appear.
USB device tree
• USB
high-speed
bus
• USB
bus
Contact and Support Information
If the product is defective:
Please contact your dealer or Hama Product
Consulting if you have any product claims.
Internet/World Wide Web
Product support, new drivers and product
information are available at www.hama.com.
Support hotline – Hama Product Consulting:
Tel. +49 (0) 9091 502 115
Fax +49 (0) 9091 502 272
E-mail: [email protected]
00049256bda.indd Abs1:9
00049256bda.indd Abs1:9
27.07.2007 11:36:39 Uhr
27.07.2007 11:36:39 Uhr
