7
Note
•
Before installing the bracket, check the installation options in your vehicle. If in doubt, check the
vehicle's instruction manual or contact the vehicle manufacturer.
•
Check the load-bearing capacity of the slats before inserting a device into the bracket. This installation
version is only recommended for devices < 300 g.
•
Never apply force when using the product or during installation.
Note
•
Be aware that the preferred adhesive surface (e.g. back of the mobile phone, satnav, etc.) must be free
from dust and grease. Use a suitable cleaner from a specialist retailer for this.
•
Be aware that car care products (e.g. dashboard spray) can in
fl
uence the pad's ability to stick. You
should therefore clean the surface carefully before attaching the pad.
•
Various environmental in
fl
uences, such as moisture in the air, sunlight, cold, etc., can impair the long-
term stickiness of the adhesive pad.
•
Possible residue on the mounting surface after removal of the adhesive pad cannot be ruled out.
•
Be aware that the mounting surface will only achieve its full load-bearing capacity after around 24
hours.
•
Be aware that, depending on the thickness of the protective cover, the magnetic adhesion effect may
be impaired.
•
Be aware that dust and dirt between the mobile phone and the inserted magnetic pad can cause
scratches.
•
Be aware that the inserted magnetic pad is made from metal and therefore may impair your mobile
phone's sending and receiving capabilities.
•
Remove the protective
fi
lm (
1
) from the adhesive side of the magnetic pad and press it into the desired
position in your vehicle (
2
) for a few seconds.
•
Remove the protective
fi
lm (
3.a
) from the adhesive side of the metal plate (round or rectangular) and press
it onto the desired mounting surface (e.g. rear of the mobile phone) for a few seconds.
•
The metal plate (
3.b
) can simply be inserted/stuck between the protective cover and the rear of the mobile
phone.
5. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper
installation/mounting, improper use of the product or from failure to observe the operating instructions and/
or safety notes.
Summary of Contents for 00201518
Page 2: ......
Page 3: ...1 2 3 a 2 3 b ...
