5
Note
•
If the batteries of the earphones and the charging box are empty,
the earphone batteries will be recharged first. After that, the
battery of the charging box will be charged (the status LEDs (3)
of the earphones go out; the status LED (7) of the charging box
continues to be lit red).
•
A charging box battery that has been fully charged allows you to
completely charge both earphones about three times.
5. Operation
5.1 Switching the earphones off/on
• Turn On:
With the device off, press and hold the
multifunction button
(1)
for three seconds until you hear a voice say ‘Power on’. The
status
LED
(3) flashes blue.
• Turn Off:
With the device on, press and hold the
multifunction button
(1)
for four seconds until you hear a voice say ‘Power off’. The
status
LED
(3) will light up in red before the device turns off.
The first time the device is turned on, pairing is automatically started
– see
5.2 Bluetooth
®
pairing – Headset.
5.2 Bluetooth
®
pairing – Headset
•
First the two earphones must connect to one another.
•
Ensure that both earphones are switched off.
•
Press and hold the
multifunction button
(1) of both earphones
for approximately five seconds until the
status LEDs
(3) begin to
alternate between a red and blue light.
•
The earphones pair with one another within about ten seconds and
can then be connected to a terminal device.
•
If the two earphones cannot set up a connection within two
minutes, they will automatically switch off.
•
If pairing was successful, you will hear a voice say ‘Connected’.
Summary of Contents for 00178881
Page 2: ...2 1 3 3 4 5 8 6 7 ...
