2
G
Operating instruction
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw your
attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or important
notes.
2. Package Contents
•
Table Clock
•
1 AA battery
•
These operating instructions
3. Safety Notes
•
This product is not suitable for lighting rooms in domestic households.
•
Do not use the product in areas where the use of electronic devices is not
permitted.
•
Do not drop the product and do not expose it to any major shocks.
•
Do not modify the product in any way. Doing so voids the warranty.
•
Keep the packaging material out of the reach of children due to the risk
of suffocation.
•
Dispose of packaging material immediately according to locally applicable
regulations.
•
The product is intended for private, non-commercial use only.
•
Use the product for its intended purpose only.
•
Do not use the product in the immediate vicinity of heaters or other heat
sources or in direct sunlight.
•
Do not operate the product outside the power limits given in the
specifications.
•
Do not open the device or continue to operate it if it becomes damaged.
•
Do not attempt to service or repair the product yourself. Leave any and all
service work to qualified experts.
•
Keep this product, as all electrical products, out of the reach of children!
•
Use the item only in moderate climatic conditions.
Warning – Batteries
•
When inserting batteries, note the correct polarity (+ and - markings) and
insert the batteries accordingly. Failure to do so could result in the batteries
leaking or exploding.
•
Only use batteries (or rechargeable batteries) that match the specified type.
•
Before you insert the batteries, clean the battery contacts and the polar
contacts.
•
Do not allow children to change batteries without supervision.
•
Do not mix old and new batteries or batteries of a different type or make.
•
Remove the batteries from products that are not being used for an extended
period (unless these are being kept ready for an emergency).
•
Do not short-circuit batteries.
•
Do not charge batteries.
•
Do not throw batteries in a fire.
•
Keep batteries out of the reach of children.
•
Never open, damage or swallow batteries or allow them to enter the
environment. They can contain toxic, environmentally harmful heavy metals.
•
Immediately remove and dispose of dead batteries from the product.
•
Avoid storing, charging or using the device in extreme temperatures and
extremely low atmospheric pressure (for example, at high altitudes).
4. Getting Started
4.1 Inserting the battery
Remove the safety film if necessary as well as the contact breaker and insert
the batteries with the correct polarity. The clock is ready for operation.
4.2 Replacing the battery
•
Remove and dispose of any used batteries. Insert the new battery (AA).
•
Ensure that the polarity of the battery corresponds to the symbols in the
battery compartment.
5. Mounting
•
Use the base to position the table clock on a level surface.
•
Alternatively, you can mount the table clock on a wall using the recess on
the back.
Warning – Mounting Note
•
Before mounting the clock, ensure that the chosen wall is suitable for the
weight to be mounted, and make sure that there are no electrical wires,
water, gas or other lines at the installation site on the wall.
•
Purchase special fastening materials from specialised dealers.
•
Do not mount the product above locations where persons might linger.
6. Operation
•
Once the battery is inserted properly, the clock will automatically start
running.
•
Use the setting wheel on the back of the clock to set the time.
7. Care and Maintenance
•
Only clean this product with a slightly damp, lint-free cloth and do not use
aggressive cleaning agents.
•
Make sure that water does not get into the product.
8. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of the
product or from failure to observe the operating instructions and/or safety
notes.
9. Technical Data
Wall clock
Power supply
1.5 V, 1 x AA battery
