6
6.2 Volume punch-through
With the volume punch-through function, the VOL+ or
VOL- commands can bypass the device currently being
controlled
and adjust the volume of a second device. All other
commands are unaffected.
To activate the volume punch-through function:
•
Press the desired device button (e.g. TV).
•
Press and hold the "VOL+" button.
•
Press the desired device button (e.g. STB).
•
Release the "VOL+" button again (the LED flashes
once when the setting is activated).
To deactivate the channel punch-through function:
•
Press the desired device button (e.g. TV).
•
Press and hold the "VOL-" button.
•
Press the desired device button (e.g. STB).
•
Release the "VOL-" button again (the LED flashes
twice when the setting is deactivated).
6.3 Macro Power
Macro Power allows you to switch two AV devices on/
off simultaneously.
To activate the Macro Power function:
•
Press the desired device button (e.g. TV).
•
Press and hold the "POWER" button.
•
Press the desired device button (e.g. STB).
•
Release the "POWER" button again (the LED flashes
once when the setting is activated).
To deactivate the Macro Power function:
•
Press the desired device button (e.g. TV).
•
Press and hold the "POWER" button.
•
Press the desired device button (e.g. STB).
•
Release the "POWER" button again (the LED flashes
twice when the setting is deactivated)
7. Learning function
This remote control is equipped with a learning function.
This allows you to transfer functions from your original
remote control to this universal remote control.
7.1 Before you start the learning function
•
Make sure that all batteries used in both remote
controls are in perfect condition. Change them if
necessary.
•
Place your original remote control and the universal
remote control next to each other so that the infrared
diodes of the remote controls are directly opposite
each other.
•
If necessary, correct the height of both remote controls
to achieve optimal alignment.
•
The distance between the two remote controls should
be approx. 3 cm.
BIG ZAPPER
ca. 3 cm
ORIGINAL
Note
•
Do not move the remote controls during the
learning process.
•
Make sure that the room lighting is not fluorescent
tubes or energy-saving lamps, as these could cause
interference and thus hinder the learning process.
•
The distance between the two remote controls and
the nearest light source should be at least 1 metre.
•
The learning process is terminated without saving if
no button is pressed or no signal is received for 30
sec. while learning mode is activated.
•
In learning mode, each button can only be assigned
one function. A new function overwrites the
function previously taught on this button.
•
The TV, STB and Setup buttons cannot be assigned
new functions.
Summary of Contents for 00040072
Page 2: ......
Page 3: ...Exit Menu AV AA 2 8 3 4 6 7 12 11 10 9 1 5 2in1 Art Nr 00040072 X1040072 ...
Page 131: ...129 ...