6
7
DUAL CONNECTOR ECU WIRING
SINGLE CONNECTOR ECU WIRING
R/L
B
Connect
to pin A10
Connect
to pin A26
HT-130043
-4 Power Supply
DTM
HT-130025
Cable
CAN
CAN Connector
Integrated into ECU
wiring harness
Haltech
Elite ECU
Spare CAN port can be
used to daisy chain other
Haltech CAN devices
(iC-7, TCA, TMS etc)
Wiring for Elite Single Connector ECUs
Connect the Haltech CAN Wideband Controller directly
to a Haltech Elite Series single connector ECU using the
CAN connector within the ECU harness, the included
DTM-4 Power Supply Cable and CAN cable DTM-4 to
DTM-4 as shown above.
Connect the DTM-4 Power supply cable RED wire to a
fused and switched 12 Volt source that has power at
Haltech WB1 connected to Elite series single connector ECU
B
R
R/L
B
Connect
to pin A10
Connect
to pin A26
HT-130025
Cable
CAN
NOTE: CAN connector within
ECU harness can also be used
Spare CAN port can be
used to daisy chain other
Haltech CAN devices
(iC-7, TCA, TMS etc)
DTM-4
Power Supply
HT-130043
Haltech
Elite ECU
Wiring for Elite Dual Connector ECUs
Connect the Haltech CAN Wideband Controller directly
to a Haltech Elite Series ECU using the included DTM-4
Power supply cable and CAN cable DTM-4 to DTM-4 in
series. Any CAN Port on the Haltech CAN Wideband
Controller can be used.
Connect the DTM-4 Power supply cable RED wire to a
fused and switched 12 Volt source that has power at
Haltech WB1 connected to Elite series dual connector ECU
Key On and Key Start positions. For ease of installation
this is available from the Elite ECU harness at Pin A26
(Red/Blue).
Connect the DTM-4 Power supply cable BLACK wire
to a good ground source. For ease of installation this
is available from the Elite ECU harness on Pin A10
(Black).
Key On and Key Start positions. For ease of installation
this is available from the Elite ECU harness at Pin A26
(Red/Blue).
Connect the DTM-4 Power supply cable Black wire
to a good ground source. For ease of installation this
is available from the Elite ECU harness on Pin A10
(Black).
