Assembly instruction
– PSD4xx positioning system
© 30.06.2021, halstrup-walcher
- 3 -
7100.006394_Assembly instruction_PSD4xx_F_EN
WARNING
The drive must only be installed and wired when it is
disconnected from the power supply.
Storage and transportation of devices
The PSD4xx positioning drive should always be stored and
transported to the place of installation in its original packaging.
Maintenance, cleaning and repair of
devices
The drive requires no maintenance. The drive may only be
cleaned from the outside with a damp cloth.
Repairs should only be carried out by the manufacturer.
Installing the device
Depending on the model, the device can be installed on the
machine using a hollow or solid circular shaft.
ATTENTION
Never apply force to the housing of
the drive, e.g. for supporting weight.
Installing a drive with hollow shaft
How to mount the drive on a shaft
Tools required: 3 mm Allen key.
Example:
Instructions:
1.
Slide the drive onto the shaft to be driven.
2.
Guide the torque support into the hole provided by the
planner.
3.
Slide the drive towards the machine base until the sealing
plate is pressed together to approx. the half thickness.
4.
Now tighten the adjustable collar screw with 4 Nm.
The drive is now installed.
Note:
Ensure that the drive and machine base are as
parallel to each other as possible.
INCORRECT
CORRECT
ATTENTION
Under no circumstances must the
drive be bolted on “hard” without an
air gap between it and the machine.
The sealing plate is used for
tolerance compensation.
Installing a drive with solid circular shaft
The drive is installed on the axle to be driven using a coupling
and an intermediate flange.
Install the drive according to the coupling manufacturer’s
specifications.
Example:
The dimensions of your device can be found in the current data
sheet on the website:
www.halstrup-walcher.de/technicaldocu
