PAGE 6
RC8*C RC12*C AND 14762 & 14700 CUP DISPENSER
97095C (Rev. E - 10/99)
INSTALLATION INSTRUCTIONS
FOR THE
RC MODEL DRINKING FOUNTAIN
(with optional cup dispenser)
1. The 14700 Model Cup Dispenser with Glassfiller is designed to complement model RCA3 drinking fountains. The fountain should
already be installed before beginning installation, if not, refer to page 2 for your model. Remove louvered access panel from
fountain via the two screws at the bottom.
2. Check wall opening to see if provisions have been made to accept this cup dispenser. If they have not, refer to page 2 for rough-
in instructions. CAUTION: Wall construction must be framed to support fountain and cup dispenser (approximately 150 pounds).
3. See Parts List Illustration (page 7) for exact location of cup dispenser tailpiece. Decide which style of waste trap you intend to
use. For easier installation, we recommend the use of a swivel trap.
4. Orientate yourself to the configuration of the cup dispenser. Open front door and remove the spring loaded trash access panel.
To remove access panel, just loosen the four mounting screws and pull out the panel. Also remove the waste bin. Note location of
mounting slots in the wall box portion of the cup dispenser. The slots are for affixing wallbox to building construction.
5. Put cup dispenser in wall opening. Determine shimming required to obtain a good alignment with fountain. Open and close door
to ensure proper operation. CAUTION: Do not suspend cup dispenser via the mounting slots - be sure to shim along bottom edge
to bear the weight of the cup dispenser.
6. Secure cup dispenser in place. Use lag screws or bolts as required by wall construction.
7. Install glass filler supply tube assembly. (Figure 11). Put glass filler fitting through hole provided in back, put fibre washer on from
the front and screw on the hexagonal mounting nut. Note that the tubing itself is flex-tubing which will enable you to hand-form as
required for installation.
8. Install glass filler. First remove the blue handle, then screw the glass filler into the glass filler fitting. Reattach blue handle.
9. Turn off supply water to the RCA-3 drinking fountain. Disconnect supply tubing from fitting located at the push button valve
assembly. Remove elbow from valve assembly and install tube tee (provided). Reconnect supply water tubing (see parts list
illustration on page 7).
10. Connect glass filler supply tubing to tee.
11. Install tailpiece assembly (as shown in Figure 12). Connect waste trap (not provided).
12. Turn on supply water and operate push button valve and glass filler. Check entire system for leaks. Water flow from the glass
filler can be adjusted by turning the flow adjusting screw (see Figure 11). In order to adjust, it may be necessary to remove, and
then reinstall the glass filler, per step 8 above.
13. Replace the spring loaded trash access panel via the four mounting screws. Reinstall louvered grill on the RCA-3 fountain.
FIG. 11