2000000501 (Rev. B - 04/23)
HTHBSM-1A, HTHBSM-2A, HTHBSMWF-1A, HTHBSMWF-2A
Page 3
INSTALLATION INSTRUCTIONS
NAMEPLATE
ALCOVE
DRAIN TRAY
TOP COVER
SENSOR LENS
FRONT VIEW
REAR VIEW
REAR CROSS MEMBER
(ON OUTER WRAPPER)
BOTTOM COVER
OUTER WRAPPER
FILTER
Pre-Installation (reference Rough-In, Fig. 1, Page 2)
1.
Ensure Wall is structurally sound
to bear the loads imparted by the HydroBoost
®
Surface Mount Bottle Filling
Station (On-Wall Bottle Filler). If necessary, install a Wall Support Carrier (not supplied).
2.
Ensure Water Supply Line
and Drain Line are sized and located as specified in the Rough-in diagram.
3.
Ensure electrical Wall Outlet
is within reach of Power Cord and is live with electrical power. See Warnings.
4.
Test GFCI before proceeding:
Push Test button to ensure power cuts off. Then push Reset before operating.
5.
Attach Service Stop Valve
(not supplied) to Water Supply line orienting the 3/8"O.D. female compression outlet
horizontally to the left. Purge water line and test for leakage. Correct any leakage.
6.
Ensure package
contains the following components:
Wall Mounting (reference Rough-In, Fig. 1, Page 2)
1.
Remove Bottom Cover from Bottle Filler
by removing two(2) screws from bottom of unit. Use a 5/32" hex
wrench (not supplied). Remove and place aside new Filter Cartridge shipped inside Bottle Filler.
2.
Remove Back Panel from Bottle Filler
by removing two(2) screws from top of unit that secures the Top Cover.
3.
Fasten Back Panel
to structurally secure wall thru eight(8) 7/16" obround holes with fasteners appropriate
for wall type. Locate Back Panel as specified in Rough-In. If necessary, attach to Wall Support Carrier (not
supplied).
4.
Ensure Bottom Cover is not obstructed
by the roughed-in Water and Drain Lines. Test by sliding Bottom
Cover up into Back Panel opening. If Bottom Cover is prevented from seating properly, reposition Water and/or
Drain Lines slightly until the Bottom Cover fits easily.
5.
Before hanging the On-Wall Bottle Filler,
ensure the Insulated Waterline is routed inside of the Rear Cross
Member. If outside the Cross Member, reposition to inside or else the unit cannot be installed properly.
6.
Hang the On-Wall Bottle Filler
onto the Back Panel, aligning three(3) tabs into three(3) slots on Rear Cross
Member.
7.
Secure Bottle Filler to Back Panel
by replacing Top Cover on top of unit and fastening with two (2) supplied
screws.
DISPENSING
NOZZLE
INSULATED
WATERLINE
POWER SUPPLY CORD
Note: Back cover not shown for clarity
