0000001032 (Rev. A - 10/13)
HTHB-OVLSEBP-I HTHBWF-OVLSEBP-I
Page 4
Figure 4 - Upper Panel Installation
Figure 5 - Fountain Installation
26
43, 44, 45, 46, 47
20
10
17
8.
Install
reset switch and mating bracket on lower fountain
(lower right bolt) for bottle filler (Fig 5). Connect the switch wire
to the extension wire on the back of the bottle filler. Wrap up
the excess cord.
9.
Attach
waste tubes (1-1/4” O.D.) to 1-1/4” O.D. slip trap.
Trap on the bottle filler side must be 1-1/2” O.D. (provided by
others).
10.
Make
final water supply connections.
11.
These
products are designed to operate on 20-105 PSIG
supply line pressure. If inlet pressure is above 105 PSIG, a
pressure regulator must be installed in the supply line.
(
Caution:
Any damage caused by connecting these products
to a supply line with pressure lower than 20 PSIG or higher
than 105 PSIG IS NOT covered under warranty.)
12.
Make
electrical connections to the bottle filler and remote
chiller. The LCD Bottle counter should illiminate.
13.
Verify
proper dispensing from the bottle filler by placing a cup,
hand or any opaque object in front of sensor area and verify
water dispenses.
Note:
the first initial dispenses might have air
in the line which may cause a sputter. This will be eliminated
once all air is purged from the line. A steady stream of water
assures all air is removed. The sensor has a 20 second maxi
mum ON time. It may be necessary to step away from the
beam a few times to purge all air. Check for leaks.
14.
Check
stream height from bubbler. Stream height is factory set
at 35 PSI. If supply pressure varies greatly from this, remove
push arm (Item 7 - Figure 8) and adjust the screw on the regu-
lator (Item 19 - Figure 7). To remove push button, remove
bottom plate (Item 8). Clockwise adjustment will raise stream
height and counterclockwise movement will lower stream
height. For best adjustment stream should hit basin approxi-
mately 6-1/2” from the bubbler. Reassemble the push bar
(Fig 8).
15.
Install
the cover plates.
16.
Optional:
Mount optional panels. Install bracket per rough-
in, slide tongue of panel under edge of already installed panel.
Tighten screws.
15
2
3
5
18
4
9
NOTE:
When installing replacement bubbler and pedestal
(Fig 6), tighten locknut only to hold parts snug in posi-
tion.
Do Not overtighten.
Figure 6 - Bubbler Detail
1
Locknut
