PAGE 5
SCWT14ACBQ*1L
1000002180 (Rev. C - 05/16)
Faucet Assembly Instructions
1.
Place the faucet spout
through the chrome cover with the smaller diameter end toward the faucet outlet.
2.
Place the chrome collar
over the faucet spout with the smaller diameter toward the bigger diameter chrome cover in step no. 1.
3.
Place the faucet spout end down
inside the same diameter hole in the brass connector.
4.
Hold the chrome collar and cover
up so you can get to the faucet set screw, turn the faucet spout so it goes toward the drain
on the cooler.
5.
Tighten the faucet set screw
gradually until faucet wil not rotate.
6.
Lower the chrome collar
and the chrome cover down to basin.
7.
Place the chrome cover
so the set screw is toward the rear of the faucet.
8.
Tighten set screw
until cover will not pivot.
9.
Place handle on faucet
with the slot toward the front of the faucet, slide the slot into the brass pin.
10.
Hold handle in snug toward faucet
making sure it is seated into the brass pin, and then tighten the handle set screw until
handle will not come off the brass pin.
11.
Removal of the handle
is exactly opposite of the assembly process.
Faucet Spout
Chrome Cover
Chrome Collar
Faucet Spout
Set Screw
Handle Set
Screw
Cover Set Screw
FIG. 6
