Halotherapy Solutions Halo STAR, Owner'S Manual, Page: 8 / 48

8
halotherapysolutions.com
Halo STAR
Assembly Instructions Cont’d
The side wall panels connect to the back wall with the installed locking brackets. There are mating brackets on
the side of each panel.
1. Place the small left side wall with the Charging Station
in the slot in the floor. Lift the side wall up about 4”
(10cm) higher than the backwall panel (See Picture 1).
2. Place the side wall panel against the back wall (See
Picture 2), then slide down side wall panel until the
two panels are equal height. (See Picture 3).
3. If the panels are not equal height or there is an
obvious gap between the two panels, this means
they are not propery attached and you should try
again.
4. Replace the steps above with the small right side
wall panel with the keypad.
4 - CONNECTING FIRST WALL PIECES
Right Side Wall Installed
Left Side Wall Installed
If the panels still seem too tight to come down all the way, try backing off the bracket screws by one half turn with a
Phillips head screwdriver on the female bracket.
Picture 3 Picture 2 Picture 1