LED Wall Pack Instructions
www.cooperlighting.com
IL51879322
6
ENGLISH
CARE AND CLEANING
TROUBLESHOOTING
•
Shut off the main power supply before cleaning the product. To prolong the original appearance, clean the light fixture with clean water and a
soft, damp cloth only.
•
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints, solvents or any other chemicals on this light fixture. They
could cause a premature deterioration of the finish and may void the warranty.
•
Do not spray the light fixture with a hose or power washer.
PROBLEM
POSSIBLE CAUSE
SOLUTION
The light does
not turn ON.
There is no power to
the fixture
• Check if circuit breaker is tripped.
• Confirm wall switch is ON. Verify wiring to the fixture is correct (turn power OFF to fixture beforehand).
The fixture senses
daylight
Cover the photocell. wait a short time until the fixture turns ON.
The light cycles
ON and OFF
continuously.
The photocell light
sensor is sensing
reflected light
• Relocate the light fixture to a location where there is no reflected light.
• OR place the optional photocell cover over the photocell light sensor and use the wall switch to turn the light ON
and OFF.
The light flickers.
The light fixture wired
through a dimmer
switch
Do not use a dimmer switch to control the light fixture. Replace the dimmer with a standard ON/OFF switch.
The light stays
ON.
The light sensor is in a
shaded area.
• Shine a flashlight into the light sensor and wait a minute. If the light turns OFF, the fixture should be moved to a
location with enough light in the daylight hours for the light sensor to work.
• OR place the optional opaque cover over the photocell light sensor and use the wall switch to turn the light ON
and OFF.
The light sensor is
faulty.
If the light does not turn OFF when a flashlight is shined on the light sensor for a minute, then the sensor may be
faulty. Please contact customer service.
