LED Wall Pack Instructions
www.cooperlighting.com
IL51879322
4
ENGLISH
5
.
MAKING THE ELECTRICAL CONNECTIONS
•
Follow the wiring instructions given below to make the electrical connections. (Fig. 1).
Junction Box
•
Remove desired conduit plug (B) from one of the fixture's sides from the where conduit
will enter. (Fig. 2)
Make wiring connections inside the fixture as per the instructions given below.
If necessary, strip 3/8 in. of insulation from junction box or fixture (A) wires (Fig.
2
).
Surface Conduit Mount
•
•
•
Connect the fixture black wire to the supply black wire ((+) line),and fixture white wire
to the supply white wire ((-) common) by twisting the exposed wires together and using
the wire nuts (
AA
). Ensure there are no loose wires.
Connect the supply ground wire to the green fixture ground wire by twisting the
exposed wires together and using the wire nuts (
AA
).
ON/OFF Wiring (Non Dimming) Method
•
•
Connect the fixture black wire to the supply black wire ((+) line,and fixture white wire to
the supply white wire ((-) common) by twisting the exposed wires together and using
the wire nuts (
AA
). Ensure there are no loose wires.
Connect the supply ground wire to the green fixture ground wire by twisting the
exposed wires together and using the wire nuts (
AA
).
Connect the purple wire to the (V+) DIM wire and the gray wire with (V-) DIM wire by
twisting the exposed wire together.
0-10V Dimmable Wiring Method
•
•
NOTE
:
Hold stripped ends near each other and align any frayed strands (do not
twist wires).
Push the wires into wire nut (AA) and use your fingers to twist the wire nut
clockwise until tight. Check for tightness by pulling wires.
(+) Line
Black
White
Lighting
Fixture
Green
(-) Common
Ground
3/8 in.
Non-Dimming Wiring Diagram
Black
White
Lighting
Fixture
Green
Purple
Gray
(+) Line
(-) Common
(+)DIM V+
(-)DIM V-
Ground
0−10V Dimming Wiring Diagram
Fig. 1
Fig. 2
6
.
MOUNTING THE LIGHT FIXTURE
•
Close the fixture by tightening the two mounting base screws (C), using a Phillips
screwdriver.
D
C
