Collar Setup
01 Important Note: Assembly
Please
DO NOT
assemble your Halo Collar or
put the collar on your dog yet. Instructions are
provided in the app under “User Training”.
02 Important Note: A Place to Charge
Find a wall outlet in a convenient location, where it
is within good range of your home WiFi
connection. This is required for Firmware
Updates.
03 Start Charging Your Collar
Turn the Halo Collar upside-down, then lift the
USB flap with your fingernail to open (do not
unscrew or use tools). Then, use the wall charger
(
d
) and USB-C cable (
e
) included in your Halo Kit
to charge. Your Halo Collar will automatically turn
ON while charging, but it will revert back to its
original state when it is unplugged again. This
typically takes appx. 2 hours to fully charge.While
charging, your Battery LED will BLINK GREEN.
Once fully-charged, your Battery LED will stop
blinking and remain ON.
04 Add Your First Pet
Tap “Add Pet” on your “Find Navigation” card, and
provide your dog’s information to create their
Pet Profile. This will prepare you for the next step.
05 Connect Your Collar to the App
While your collar is charging, tap
Settings Collars Add Collar
in your app to view
your Collars List. Scan your Halo Collar’s QR code,
or enter the serial number provided. You can find
your QR code on the side of your Halo Kit box, or
on the inside/back of your Halo Collar. Follow the
steps in the app to set up your collar and link it to
a Pet Profile.
06 Connect Collar to WiFi
During this process, you will be prompted to
connect your collar to home WiFi. If you have
issues, follow the in-app troubleshooting tips.
07 Firmware Updates
While charging and connected to WiFi, your Halo
Collar will automatically update to the latest
firmware. Your Battery LED will BLINK RED while a
firmware update is in progress. Firmware updates
will automatically pause if interrupted (due to WiFi
connection or being removed from charger), and
will resume when plugged back in to charge and
reconnected to WiFi.
08 Important Note: Collar Mode Buttons
Navigate to the My Map tab, then tap on your
pet’s profile photo in your Pets List. This will bring
up your Pet Card, which allows you to manage the
collar modes and preference for this pet. Make
sure that your pet’s collar mode buttons are set to
“Fences OFF” and “Beacons OFF” until you have
both
a)
calibrated your collar’s GPS and
b)
trained
your dog to use these features. Further
instructions included in future steps.
#05
