Halma Ocean Optics JAZ, Installation And Operation Manual

Page: 51 / 70

5: Operating the JAZ-INDY Module
013-RD000-000-02-201510 41
Menu Item Description
Module Info Allows you to display the Indy module serial number where:
v = the CCA revision
xxxx = the 4-digit number of the device
Calibrate Select to measure the following:

voltage out: in counts or volts

voltage in: in counts or volts

4
– 20 mA Transmit

4
– 20 mA Receive
See Calibrating the JAZ-INDY Module for the calibration procedures.
JAZ-INDY Menu Defaults
When you first power-on the Jaz stack, the JAZ-INDY module defaults to the following settings:
Setting Default Value
GPIO Menu
Set Direction 1-8: Input
Set Output Values does not appear until one of the 1
bits is changed to Output
Analog V Out
V Output - 5.00
4-20mA Excitation
4-20mA Excitation 10 Volts (+)
4-20mA Tx Control
Set Value .0
Calibrating the JAZ-INDY Module
Your JAZ-INDY module is calibrated at the factory, but you can use the procedures in this section to
recalibrate the module so that it matches your equipment.

You can calibrate the following on the JAZ-INDY module:

Four voltage outputs