Hall Technologies October 6, 2023
Page 6 of 16
Setup
Installation
•
Optionally,
connect an HDMI source to the HDMI IN connector. Note that a source is NOT
required to embed audio onto the HDMI output.
-
If there is no HDMI source signal, the HDMI Output will be a 640x480 (480P) black screen.
•
Optionally,
connect an HDMI compatible sink to the HDMI OUT connector. A sink is not
required to extract the HDMI Input Audio.
•
Optionally,
connect the SPDIF OUT audio output to a compatible audio device.
Optionally,
connect the L/R OUT analog audio output to a compatible device (e.g., headphones,
assistive listening devices).
•
Optionally,
connect the audio to embed to the SPDIF IN and/or L/R IN connector(s).
•
Optionally,
Connect the TX, RX and GND contacts on the Control terminal strip to a compatible
controller (e.g., PC or RS-232 controller).
•
Optionally,
Connect the DI contact on the Control terminal strip to a compatible normally open
dry contact. This can be configured to mute the audio and/or video. Factory default is to mute
the audio output. (Closed = MUTE)
•
Optionally,
use the included rack mount brackets and hardware. The brackets are configurable
for different mounting orientations.
•
Connect the included power supply to the 5V DC connector.