Halfords 456686 Instructions Download Page 2

WARNINGS

• 

 Before use, check that the cables, plugs and casings are 
undamaged. DO NOT use if any parts are damaged or worn. 

• 

 DO NOT use in the rain, or other wet or damp 
conditions. DO NOT handle if your hands are wet. 

• 

 DO NOT obstruct the air flow to the unit. The 
ventilation slots must be kept clear for the unit to work 
properly and prevent dangerous overheating. 

• 

 DO NOT place the unit in direct sunlight or an enclosed space where 
ventilation is restricted, or where there are other heat sources. 

• 

 Avoid using in areas where the supply cables may 
become a trip hazard and DO NOT sit or stand on it. 

• 

 As with all electrical equipment, keep away 
from children and animals. 

• 

 Only use with a 12/24V DC (negative earth) or a 230-240V 
AC electric supply. When using a 230-240V AC mains electric 
supply it is advisable to use a residual current device (RCD). 

• 

 When using the coolbox with the 12/24V DC supply, the 
plug will become warm during use. Ensure that the vehicle 
socket is clean and clear of debris, and the electrical 
contact is good to avoid the plug/socket overheating. 

• 

T ake care when removing the plug from the 12/24V DC socket 

and DO NOT touch the metal contacts which may be hot. 

• 

 Unwind the supply cable fully before use. DO NOT use whilst this 
cable is coiled or folded as this can cause overheating of the cable. 

• 

 This coolbox is intended for keeping foodstuffs cool. It is not 
recommended or intended for medicines or chemical storage. 

• 

 This coolbox is intended for temporary in-vehicle, camping, 
caravanning and leisure use. It is not a fridge or cooker designed 
for permanent installation and should not be used as such. 

• 

 NEVER fill the unit with water or ice. DO 
NOT immerse the unit in water. 

• 

 Ensure the vehicle’s engine is running before the 12V 
DC plug is connected. This will avoid power surges 
which could potentially damage the coolbox. 

• 

 Disconnect the unit whilst the vehicle’s engine is 
not running to prevent the vehicle battery becoming 
excessively drained or flat. When the vehicle is running, 
the alternator should provide enough power. 

• 

 To maximise the cooling or warming effect after the 
unit is disconnected, keep the lid closed. 

• 

 Take care when manoeuvring or lifting the coolbox 
as it may be heavy when fully loaded. Only lift if it 
is within your own physical capabilities. 

• 

 NEVER pull the plug out of the 12V socket using the 
cable, or pull on the cable to manoeuvre the coolbox. 

USE & OPERATION

GENERAL SET UP

1.   Load the coolbox with your food and drink in suitable containers. 

To obtain the best performance from your coolbox, it is 
recommended that these items are already cold. The addition of 
any substantial amount of food at room temperature will slow the 
cooling performance. 

2.   Select the power supply according to your requirements.
There are two power options:
  1.   12/24V DC (negative earth) plug and power cord for use 

in a vehicle.

    

Note: The vehicle ignition may have to be turned on to 
supply the coolbox with power.

  2.   230-240V AC three pin mains plug for use in the home 

or camp site.

When the coolbox is connected to a mains supply, it can be 
operated in two modes:

 

ECO mode where the cool box consumes less energy, 
select the dial range between MIN to ECO.
MAX mode where the coolbox is set to maximum cooling.
The cooling control knob is located inside the cable storage 
compartment.
To increase the cooling, turn the cooling control knob clockwise 
towards MAX.
To decrease the cooling, turn the cooling control knob counter 
clockwise towards MIN.
Note: When the coolbox is connected to a 12V/24V DC socket, 
it cools at the maximum setting and the cooling cannot be adjusted.

3.   Ensure the unit is in a position in the vehicle where it cannot fall over 

easily. If using the coolbox outside of the vehicle, place it on a firm, 
flat surface in the desired location. Use the fold out handles and 
wheels to pull along, manoeuvre and lift.

4.  Fully extend the power cable required and plug in.
5.   The cooling performance is similar to that of a household fridge 

(NOT a freezer).

The temperature inside the coolbox will be lowered to about 16°C 
below that of the surrounding (ambient) air.
6.   After use, disconnect the electrical supply. This appliance can be 

used by children aged from 8 years and above and persons with 
reduced physical, sensory or mental capabilities or lack of experience 
and knowledge if they have been given supervision or instruction 
concerning use of the appliance in a safe way and understand the 
hazards involved. Children shall not play with the appliance. 
Cleaning and user maintenance shall not be made by children 
without supervision.

CLEANING & STORAGE

1.  Switch the unit to OFF and disconnect the electrical supply cable. 
2.   Carefully fold up the cable and store in the convenient cable storage 

compartment provided. 

3.   The coolbox surfaces can be wiped clean using a cloth with mild 

detergent solution. 

4.   The coolbox should not be cleaned using running water or by 

immersing in water. Abrasive cleaning materials should also be 
avoided. 

5.   When not in use the coolbox lid should be left ajar to prevent 

mould growth. 

Summary of Contents for 456686

Page 1: ...nings and instructions below carefully and familiarise yourself with the product before use As with all electrical items please exercise extreme caution during use and take care not to misuse or damage the product which could result in injury 40L Electric Coolbox Instructions ...

Page 2: ...1 Load the coolbox with your food and drink in suitable containers To obtain the best performance from your coolbox it is recommended that these items are already cold The addition of any substantial amount of food at room temperature will slow the cooling performance 2 Select the power supply according to your requirements There are two power options 1 12 24V DC negative earth plug and power cord...

Page 3: ...he plug and or socket using a non metallic tool The plug has not been inserted properly into the socket poor electrical contact Pull plug out gently from the socket and re insert firmly Repeat the operation until the proper position is found the plug is aligned securely in the socket The fuse of the 12V plug has blown Replace the fuse 8A in the 12V plug by unscrewing the end of the plug The vehicl...

Page 4: ...WEEE marked waste products must not be mixed with general household waste but kept separate for the treatment recovery and recycling of the materials used For proper treatment recovery and recycling please take all WEEE marked waste to your Local Authority Civic waste site where it will be accepted free of charge If all consumers dispose of Waste Electrical Electronic Equipment correctly they will...

Reviews: