Orb-85 Electronic Dartboard 3
This dartboard may have a protective film over the LCD display. Film should
be removed for better clarity.
See page 4 for details.
Setup / Mounting Instructions
Choose a location to hang the dartboard where there is about 10 feet of open space in front
of the board. The “toe-line” should be 7’ 9 1/4” from the face of the dartboard. Since this
dartboard is powered by 4 “AA” batteries (not included), you are not limited in having to
mount it close to an electrical outlet, so it can be mounted anywhere you have the space.
However, you may choose to mount it close to an electric outlet in case you decide to use
the
optional
A/C adapter, which can be purchased directly from Regent Sports (See page
20 for ordering information)
Locate a wall stud and place a mark 601/4 ” from the floor. Place another mark 15 ¾
”
directly above the first mark (76” from floor).
Center of Bullseye should be 5’ 8” from the
floor.
Insert 2 mounting screws in the center of the stud using the marks you made as guides. Be
sure the top screw is directly above bottom screw to ensure dartboard will be level.
Mount the dartboard on the wall by lining up the holes on the back with the screws. It may
be necessary to adjust the screws until the board fits snugly against the wall.
Insert 4 “AA” batteries in the battery compartment on front side of dartboard (diagram inside
compartment).
It is recommended you
r
emove batteries if using the optional AC
adapter.
X
X
Wall Stud
Bottom
Screw
60 1/4”
Top Screw
76”
Floor
7’ 9 ¼”
Toe Line
5’ 8” from Floor
to Center of
Bullseye
Dartboard
