4.5 Operating procedure
O
Turn on switch "C" the brush is
rotating .
O
Turn the lever up , to discharge the
detergent and position the lever su-
itably to achieve the desired flow of
Detergent.
O
Lower the brush head.
O
Lower the squeegee.
O
Turn on switch A the suction
turbine is running.
Note:
After lowering the brush move
the Hakomatic E 430 immediately;
Otherwise the brush might leave tra-
ces on the floor. Lift the squeegee
during reverse travel.
During work, the power supply cable
Should be lying behind the operator.
When passing over dormers with a
height of more than 0.70in =10mm,
The brush drive must be turned off
and the brush must be lifted up.
Caution :
Danger when passing over
the power supply cable while the brush
is rotating.
Cleaning of floor areas starts from the
outlet socket and is effected stripe by
stripe. In case of unoccupied areas it
will be useful to
Clean at first the border areas, passing
with the machine along those areas in
counterclockwise sense.
Cleaning of the remaining areas then
should be effected stripe by stripe,
starting from the outlet socket.
Partially occupied areas should be
subdivided into single working areas,
within reach of the power Supply ca-
ble. Within short time, the operator will
learn how to avoid unnecessary en-
cumberments caused by the cable.
16
4. Taking into operation
4.5 Operating procedure
O
Turn on switch "C" the brush is
rotating .
O
Turn the lever up , to discharge the
detergent and position the lever su-
itably to achieve the desired flow of
Detergent.
O
Lower the brush head.
O
Lower the squeegee.
O
Turn on switch A the suction
turbine is running.
Note:
After lowering the brush move
the Hakomatic E 430 immediately;
Otherwise the brush might leave tra-
ces on the floor. Lift the squeegee
during reverse travel.
During work, the power supply cable
Should be lying behind the operator.
When passing over dormers with a
height of more than 0.70in =10mm,
The brush drive must be turned off
and the brush must be lifted up.
Caution :
Danger when passing over
the power supply cable while the brush
is rotating.
Cleaning of floor areas starts from the
outlet socket and is effected stripe by
stripe. In case of unoccupied areas it
will be useful to
Clean at first the border areas, passing
with the machine along those areas in
counterclockwise sense.
Cleaning of the remaining areas then
should be effected stripe by stripe,
starting from the outlet socket.
Partially occupied areas should be
subdivided into single working areas,
within reach of the power Supply ca-
ble. Within short time, the operator will
learn how to avoid unnecessary en-
cumberments caused by the cable.
16
4. Taking into operation
Summary of Contents for Hakomatic E 430
Page 1: ...Instruction Manual Hakomatic E 430 7324 12...
Page 29: ......
