Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
www.haklift.com
Lifting Solutions Group
Axel Johnson International
WARNING:
THIS IS A LIFTING DEVICE ONLY. IT IS DESIGNED TO LIFT PART OF THE VEHICLE (ONE WHEEL OR
AXLE). ALWAYS WEAR SAFETY GLASSES WHEN USING THIS EQUIPMENT. CENTER LOAD ON
SADDLE BEFORE LIFTING. NEVER WORK ON, UNDER OR AROUND THE LOAD UNTIL IT IS PROPERLY
SUPPORTED. DO NOT USE THIS PRODUCT FOR ANY PURPOSE OTHER THAN THAT FOR WHICH IT
IS INTENDED FOR. IT IS OWNERS RESPONSIBILITY TO KEEP LABELS AND USER INSTRUCTIONS
AVAILABLE AT ALL TIMES.
BEFORE USE
1. Verify that the product and the application are compatible. If you are in doubt contact the reseller.
2. Before using the product, read the user manual completely.
3. Open the release valve (counter clockwise max. 2 turns)
4. With ram fully retracted, locate and remove the oil filler plug. Insert the handle into the handle sleeve,
then pump 6 to 8 strokes. This will help release any pressurized air which may be trapped within the
reservoir. Ensure the oil level is just below the oil filler plug hole. Re-install the oil filler plug.
5. Pour a teaspoon of good quality air tool lubricant into the air supply inlet of the lift control valve (see
illustration). Connect to air supply and operate for 3 seconds to evenly distribute lubricant.
6. Check to ensure that jack moves smoothly and that the pump operates smoothly before putting into
service. Replace worn or damaged parts and assemblies, use only spare parts which reseller has
approved.
7. The product is compatible with the ¼'' NPT air connector. When installing the connector, make sure the
connection is secure, for example with a pipe tape.
8. Inspect the device before each use. Do not use the appliance if you notice a bent or broken part.
OPERATION
Lifting:
1. Assemble 2 pcs of handles and ensure that spring clips align with slots.
2. Secure the load to prevent inadvertent shifting and movement.
3. Position the jack near desired lifting point.
4. Close the release valve by turning it clockwise until it is firmly closed.
5. Insert and secure handle into handle sleeve. Push the handle until the saddle rises up to the lifting
point. Do not attempt to use the device for lifting other than with the handle mechanism or lift control
valve. Release the handle to halt the lift. Never lock the air control valve by clamping, only to be
operated by hand.
6. Raise the load to the desired height and support the jack immediately with supporting elements.
USE THE HANDLE PROVIDED WITH THIS PRODUCT OR AN RESELLER AUTHORIZED REPLACEMENT
HANDLE TO ENSURE PROPER RELEASE VALVE OPERATION. DO NOT USE AN EXTENDER ON THE
AIR HOSE NOR THE OPERATING HANDLE.
ONLY LIFT AT VEHICLE MANUFACTURER’S
RECOMMENDED LIFTING POINTS. AFTER LIFT IMMEDIATELY SUPPORT WITH JACK STANDS.