Haklift Oy
Asessorinkatu 3-7
20780 Kaarina, Finland
Tel. +358 2 511 5511
www.haklift.com
Lifting Solutions Group
Axel Johnson International
5.
Insert the new chain into the load sheave.
6.
Feed the new chain into the chain hoist.
7.
Allow about 40cm of chain below the chain hoist on the slack end.
8.
Attached the chain stop and load block assembly. Be sure there are no twists in the
chain.
9.
Important safety instructions for battery chargers
This battery charger is not suitable for Univolt batteries. It should not be used to charge Ni-MH
batteries.
CHECK BEFORE USE
1. The power source
◼
Observe correct main voltage. The voltage of power source must agree with the voltage specified in the
name plate.
◼
Make sure the rated voltages in the electric winch and the battery are the same. When the rated voltage
of the battery is higher than that of the electric winch, the motor can be damaged by fire.
