Hakko Electronics Monitouch V Series, Reference Manual

Page: 375 / 746

Chapter 11 Time Display/Calendar
11-10
Correcting Calendar Data
Correct calendar data that has become different from the actual time. The
setting method varies depending on the part selected. Check the table on page
11-1 and correct the data appropriately.
Correcting Calendar Data with Bits in the Read Area
PLC with Calendar Function
1. Correct time-data in the calendar memory of the PLC as described in the
PLC manual.
2. Set bit 11 (calendar setting) (0
→
1) of read area “n” that is set in the [Comm.
Parameter] dialog. The V series reads calendar data from the PLC.
PLC without Calendar Function
1. Write correct time-data in the memory specified for [Calendar] in the [Comm.
Parameter] dialog that is selected from the [System Setting] menu.
2. Set bit 11 (calendar setting) (0
→
1) of read area “n” that is set in the [Comm.
Parameter] dialog. The set calendar data is read.
Example:
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
2002
4
10
12
30
0
04/01/02
09:00:00
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
2002
4
10
12
30
0
04/10/02
12:30:00
D100
D101
D102
D103
D104
D105
D100
D101
D102
D103
D104
D105
run
stop
D0
Calendar memory: D100 to 106
Read area
D0 to 2
(1) Set data.
D100 = 2002
D101 = 4
D102 = 10
D103 = 12
D104 = 30
D105 = 0
(2) Set bit 11 of D0 of read area.
Calendar readout