©1997, AMERICAN HAKKO PRODUCTS, INC.
ALL RIGHTS RESERVED
9
INSTALLATION.
SETTING UP THE HJ3100.
These installation instructions and descriptions are perforce general, because no two installations are the same. The
sample descriptions and diagrams that follow are intended to give the user an indication of the several ways in which the
Hakko HJ3100 may be used. American Hakko Products will be pleased to help you arrive at the appropriate layout and
choice of accessories to fit your requirements.
Basic installation.
The Hakko HJ3100 may be installed in any location, and at any orientation, that allows access to the power switch, and
to the filters when servicing is required. Figure 2, below, gives the minimum clearances required for installation.
Following is a basic check list. Before operating the Hakko HJ3100, take note of these simple instructions:
1. Place the Hakko HJ3100 in a convenient location near an appropriate electrical outlet.
2. Ensure that exhaust air from the HJ3100 will not stir up unwanted dust, or adversely affect nearby operations.
3. Allow sufficient clearance to remove the top cover for access to the filters. See figure A-1 for an outline drawing of the
unit.
4. Before attaching accessories to, or starting, the HJ3100, remove the top cover and verify that all filters are properly
positioned.
5. If noise in the work area is a concern, attach a 999-171 muffler to the exhaust grille of the HJ3100. This will reduce
the output noise by 5 dBA.
Figure 2.
Required clearances for installation.
Bottom of bench
11.5" (two ports)
999-189 3" Neoprene duct
minimum bend radius = 3"
16" (four ports)
