9
14
■
Password setting
If selecting the Restricted, perform the setting for password.
If selecting the Partial, choose whether or not the password function is needed when changing
the set temperature, the preset number and the offset value and set the password.
Select and input three letters for password from six letters as follows.
Example
：
The procedure for changing the set temperature when the unit is restricted by a password.
(password is AbC)
●
20
：
Ready signal delay time
You can set the delay time after the HAKKO FU-601 gets ready (ie., the temperature of the tip
reaches the set value) until the Iron Ready signal becomes on.
Delay time setting range : 0
-
60 sec.
The tens digit begins to flash when coming to the delay time entering mode.
Use the method for setting the temperature to enter and set the delay time.
If you enter a value outside the delay time setting range, the display returns to the tens digit,
and you have to enter a correct value.
CAUTION
・
If the password you entered is incorrect, you cannot enter the setting
change display.
・
If you enter the password incorrectly twice in a row, the display will
return to the previous display.
Example
：
350 to 400℃
1.Press and hold the button for at least one second.
The hundreds digit will begin to flash.
2. Entering from hundreds to units digit
Press the or to set the desired figure.
Only values from 0 to 5 can be selected when entering the hundreds digit.
(In ℉ mode, values from 1 to 9 can be selected.)
Values from 0 to 9 can be selected when entering the tens or units digits.
(The same values can be selected in ℉ mode.)
When desired figure is displayed, press the button to enter.
The next digit will begin to flash. After entering the units digit, press the button to save
the figure to the system memory and begin heater control with new setting temperature.
Changing temperature setting
The temperature range is from 50 to 500℃. ( 120 to 940℉)
●
If you enter a value outside the temperature setting range, the display returns to the hundreds
digit, and you have to enter a correct value.
Press and hold the button
for at least one second.
If power is switched off or lost during the execution of this procedure, no data will be entered.
The entire procedure must be repeated from step 1.
Press the button once.
Press the or button.
Press the or button.
Press the button once.
Press the button once.
CAUTION
CAUTION
The letters for password
Press the button
once.
Press the button
twice.
Press the button
once.
Press the button
three times
Press the button
once.
Press the button
once.
Press the button
once.
●
23
：
Cable length setting
By setting the iron cable length, you can adjust the output power.
Selection of cable length : 3m, 5m, 8m
Select the cable of the kind used.
CAUTION
Be sure to selected the length of the cable when you use a different lengths of the cable.
Failure to do this may result in a tip temperature that is much higher or lower than the
previous one.