Hakko Electronics FR-702, Instruction Manual

Page: 45 / 72

44
19. INITIAL SETUP (Hot air)
The front panel of HAKKO FR-702 (Hot air) includes five operation buttons.
- Used to start or stop the station.
•Pressing this button when the forced cool down bypass is enabled will turn the airflow
off and stop the cooling process.
- Used for changing values.
•Pressing this button when using Preset Mode will cause the preset selection screen to appear.
- Used for changing values.
•Hold this button for at least two seconds to enter the Offset Mode.
- Used for finalizing entered values and checking settings.
•Hold this button for at least two seconds to display the temp/timer screen.
- Used to set air flow.
•
When setting the airflow, you may press or to finalize your airflow
setting value.
●
Operation and indication
Switch and control button
A. Handpiece
NOTE:
The handpiece can be used with the provided vacuum
pipe control knob (L).
CAUTION
The nozzle and pad will be heated at high temperature. Cool them before replacement.
●
Using vacuum function operative nozzle
1. Attach the nozzle.
a. Extend the vacuum pipe using the vacuum pipe control knob.
b. Pass the vacuum pipe through the nozzle hole and attach the nozzle.
CAUTION
●
Vacuum pipe
Do not use excessive force. When not using a nozzle,
retract the vacuum pipe to the shortest length.
●
Using vacuum function inoperative nozzle {N51-01(G), N51-05(G)}
a. Retract the vacuum pipe to the shortest length using the vacuum pipe
control knob.
b. Tighten the nozzle mounting screw.
CAUTION
●
Pad
The pad does not last indefinitely. When it becomes deteriorated, replace it. Since exposure to
high temperatures causes it to deteriorate faster, Hakko recommends it be cooled after use.
2. Attach the pad.
a. Attach the pad.
b. Adjust the pad to an appropriate position.
Adjust the vacuum pipe so that the pipe and pad protrude as little as possible.
NOTE：
Letter G is marked on the
nozzle with the pipe guard.
←A A
Pipe guard
CAUTION
The new N51-01/N51-05 nozzle has a pipe
guard inside. These nozzles could not be
attached to HAKKO FR-702 when the vacuum
pipe is extended. Do not use excessive force.
CAUTION
When “G” is not marked on the nozzle, these nozzles do not
have space to blow hot air. using them with the HAKKO FR-702
may result in danger.