Hakko Electronics FP-948, Instruction Manual

Page: 54 / 68

53
日
本語
中 文
English
7. PARAMETER SETTINGS
The MODEL FP-948 comes from the factory
with the following values preset.
IRON 1 IRON 2
°C or °F °C
Power save 0 0
Low temperature alarm setting 150°C
Resetting the supervisor or
operator control setting
4 0
Setting temperature 350°C 350°C
1 °C of °F temperature display
The MODEL FP-948 has the following four
parameters:
1) °C or °F temperature display selection
2) Power save
3) Low temperature alarm setting
4) Supervisor or operator control setting
Once the station enters parameter mode, set
the parameters in the order shown below.
Once all the parameters have been set, normal
operation will be resumed.
1. Turn power OFF.
2. Insert the control card into the card slot in the
front of the unit.
3. Press and hold down the and buttons
simultaneously, and then turn power ON.
4. Hold and buttons down until the display
shows (Celsius) or (Fahrenheit).
When either the display shows either or
, the station is in parameter input mode.
●
Pressing either the and button will cause
the display to alternate between or .
●
When the desired scale is displayed, select
by pressing the button. The system will
automatically sequence to power save mode.
2 Power save setting
Power save is an optional setting MODEL
FP-948 has 2 selections of power save. In case
power save is not required, select 0 and press
button.
Set up power save function
0 Power save is not set
15 Sleep function starts after 15 minutes
30 Auto power shutoff function starts after 30
minutes
1. When the system entered this mode, the display
shows which is the status of IRON 1
2. The display will turn to
by pressing or button.
3. Allow the display to show your favorite dura-
tion and press the button. Then,
comes up to the display window, that is the
status of IRON 2.
4. Select your favorite duration with or button
and press button as you did for IRON 1.
Note:
and are displayed only for the
first time. From the next time, your set duration
will display.