Hakko Electronics FM-2023, Instruction Manual

Page: 28 / 36

中 文
English
日本文
27
4. PART NAMES
Heat resistant pad
Tip ID number key
Plug Fixing flange
21
Holder clip
Component bed
Cleaning sponge
Tip
Plug
Cord
Handle
Button
5. SETTING UP THE MODEL FM-2023
Push the plug in as far as
it will go, and try to remove it
without pressing the release pin.
If it stays in the receptacle
it is properly seated.
Receptacle
When the plug ‘clicks’,
it is fully inserted.
1. Connector cord
Pass the connector cord through the
hole in the heat resistant pad.
2. Iron holder
Attach the holder clip to iron holder
no.634-01 or 634-02.
Hang the lower hook of holder clip on
the lower wire of the iron holder and at-
tach it with the screw.
(Setup follows)
1. Do not let the tips extend beyond the
back of the iron holder base.
(See drawing No.1)
2. Before tightening the screw, make sure
that the 2 projections of holder clip
are touching the upper wire of the iron
holder. (See drawing No.2 and No.3)
3. Connections
1. Connect the plug to the MODEL FM-202.
2. Place the MODEL FM-2023 in the iron
holder.
3. Plug the power cord into the power supply.
Be sure to ground the unit.
NOTE:
This product is protected against electrostatic dis-
charge and must be grounded for full efficiency.
No.3
No.2
No.1