Haivision Makito, User Manual

Page: 185 / 294

CLI Command Reference
audenc
Makito User’s Guide, v2.1.0, Issue 01 185
audenc
S
YNOPSIS
audenc ID start
audenc ID stop
audenc ID set parameter=value [parameter=value …]
audenc ID get [config, stats, all]
D
ESCRIPTION
The
audenc
command is used to manage encoder audio acquisition settings. The
audenc
start
and
audenc stop
commands can be used to start and stop encoding of the audio
input.
ID
is either the Encoder ID (
0
or
1
) or
all
. (Note that
0
corresponds to “High” and
1
corre-
sponds to the “Low” stream. See “HiLo Audio Streaming” on page 77.) By default, the
High audio encoder is activated.
A
CTIONS
AUDENC
P
ARAMETERS
start
Activates encoding of the audio input.
For HiLo audio streaming (i.e., to send “High” and “Low”
bitrate streams to two different destinations), you need to
manually start the Low audio encoder (
audenc 1 start
)
because it is disabled by default.
stop
Stops (mutes) encoding of the audio input.
set
Modifies encoder audio parameter(s).
A series of one or more
parameter=value
pairs can be
specified at once. See audenc Parameters below.
get
Displays encoder audio status information.
You can specify configuration, stats, or all audio information.
help
Displays usage information for the
audenc
command.
Parameter Default Description/Values
input Analog The type of Audio Input for the encoder:
Makito • Analog