MANOK plus
Installation
68
Order h49 7144.907-333
INFORMATION
When installing the changing part, ensure that it gets
installed in the right direction to enable the clamping
screw on the radially clamped changing part variant to
engage in the groove in the changing part.
When installing the base end-stop, the ground side
must face forwards.
1. Place the changing part into the product.
2. Screw in the clamping screws on the changing part and
tighten to the specified tightening torque [see Nomen-
clature].
3. Unfasten and remove the grab handle if used, or the
auxiliary tool.
