B-Top
Maintenance
86
Order h49 7144.907-333
11.4 Visual inspection
Perform a daily visual inspection of the product to identify
any damage to the product at an early stage.
Check the product for cracks and damage, in particular on
the clamping and end-stop surfaces.
A check is also required to ensure that all fixing screws are
tightened down.
If damage is detected, the relevant components must be ex-
changed immediately for genuine spare parts from the man-
ufacturer.
Complete cleaning of the product is required if heavily soiled
[see »Cleaning« chapter].
11.5 Lubricating the product
DANGER
Serious injuries caused by workpiece being
ejected centrifugally due to insufficient lubrication
of the product!
Never drop below the lower limit value for clamp-
ing force [see »Clamping force speed diagram«
chapter].
Always comply with the maintenance intervals
[see »Maintenance schedule« chapter].
Lubrication takes place every time the system is cleaned,
maintained or assembled, and also when required.
The product is equipped with grease nipples.
WARNING
Collision impact and cut injuries can be caused by
slipping when applying grease with a high-pres-
sure grease gun!
Ensure that the high-pressure grease gun is posi-
tioned correctly.
1. Move the product into release position.
2. With the help of the high-pressure grease gun [not in-
cluded in the scope of delivery], apply grease evenly via
the grease nipple.
Chuck size
Number of strokes
165
2
215
4
260
4
315
4
Table 7:
Number of strokes
