10
6. Use of the SSL-8-R1 fall arrester
Attaching and removing the
fall arrester SSL-8-R1
1. Before using the fall arrester, the fixed and
integral spring hook on the shock absorber must
be clipped onto the retaining eye on the safety
harness, which should be put on beforehand - in
accordance with EN 361.
Observe the safety instructions on page 5-8!
2. The fall arrester must be attached to the ar-
rester rope in the correct direction of pull (red
arrow pointing upwards [D] ).
3. When attaching the fall arrester, ensure that
the thumb grips the fall arrester and the index
finger is below the brake lever [E] when pulling
the brake lever upwards.
4. Use the other hand to loosen the knurled thumb
screw [F] and release the lock on the cover [G],
while at the same time opening the cover.
The fall arrester is then attached laterally to the
fall arrester rope.
5. After it the fall arrester has been attached,
close the cover [H] and tighten the knurled
screw [F].
